Foam To Air, Also makes Balsa Fly!!

After succesfully produce many Depron indoor planes it is now time to expand the list of FoamToAir planes!
Currently there are two short kits available for the planes shown below.

Classic Aileron Trainer...


The somewhat older Rc Pilots might remember the Robbe Puma. This plane was available in low-wing and high-wing configuration.
For many pilots this was their aileron trainer. In those noisy days equiped with a 6.5cc two-stroke.

The FoamToAir Puma is the same plane, but in a modern building method. All parts are CNC cut and are interlocking. Modest building skills are required. Especially for building the wing. Some sheeting needs to be applied, and a little experience is usefull.

The Puma is layed out for electric propulsion. We choosed to go for 4000mAh/5S LiPo's which will give you great power but also long flights.

MotorNTM 42-48 650KV / 1295W
Motor/prop mountbestel dit mee


All CNC cut parts for Fuselage, Wing, horizontal and vertical stabilizer.
Euro 60,00

CNC-All Wood
Same as CNC shortkit, but now also the spars and sheeting is added. The spars are 4 lengths of 5x8 spruce, sheeting is 8 sheets of 2mm balsa.
Euro 75,00

Thin ABS canopy is available from Hobby-In. I can add this to the kit
Euro 3,50

Landing gear
We are using the 2KG Carbon landing gear from PT-models, available trough Aerobatics
Euro 17,50
(Click on the image to see building pictures)

Fly Fast and low, our little beast ...

This is a nice little plane to fly with. It's low weight (around 1000gr ready to fly) makes this an easy puppy to fly around at low throttle.

But when you open up the throttle (when equiped with the E2K Pylon Race motor/prop/lipo combo), this puppy becomes a fire breathing dragon and moves around like .... a pylon racer

The 'Slipher' can turn on a dime and does not brake out of a tight turn. At full speed it's will go where you point the nose to... but the Slipher will never get mean!
Just throttle back and the beast turns back to a cute puppy that can easily be landed at your feet.

MotorTurnigy Aerodrive SK3 - 3536-1400kv
LiPo4S 2200mAh
Prop8x6 Apc


All CNC cut balsa and ply parts for Fuselage, Wing, horizontal and vertical stabilizer. GFK motormount, aileron and elevator horns
Euro 42,50

CNC-All Wood
Same as CNC shortkit, but now also sheeting is added. The sheeting is 4 sheets of 2mm balsa.
Euro 50,00

The Slipher Logo as Sticker
Black or White, other colors by request
4,50 euro

(Click on the image to see building pictures)
Setup for first flight
Center of Gravity55-65mm from leading edge
Elevator (race setup) 5mm up/3mm down.
Elavator (normal flying) 5mm up/down.
Ailerons (race setup) 4mm up/down
Ailerons (normal flying) 5mm up/down